Something in the world of floating have you stumped?
Show Highlights
In this short, salty, and to the point episode, Graham and Ashkahn talk about installing float tanks on the second floor and how to work with contractors and engineers to determine if you need to reinforce your building to support the weight.
While you usually don’t need reinforcement, it’s always good to check. Listen in above or check out the transcript below and, as always, be sure to send us your questions. All questions welcome, from basic industry questions to well crafted stumpers. If Graham and Ashkahn don’t know the answer, they still relish the journey of discovery and educated guessing.
Show Resources
Listen to Just the Audio
Transcription of this episode… (in case you prefer reading)
Ashkahn: We’ve got a question today about being on the second floor of a building with your float center. So, if you’re thinking about putting a float center on the second floor, do you need to do any structural reinforcement to hold the weight of the float tank?
Graham: Let me just say definitively that, it totally depends.
Ashkahn: Yeah, that I think is a very concrete answer.
Graham: Of course, it’s going to depend on the building, how new your construction is, whether you’re in a big multi-story concrete kind of building or whether you’re in an old wooden Victorian house. There’s a lot that goes into it, but shockingly, the overall answer in almost all of those cases tends to be no. You don’t really need to do any extra reinforcement.
Ashkahn: Yeah, most times people bring in a structural engineer to take a look at things and examine it. Often landlords will even require you to do that.
Graham: Which you totally should do, don’t just listen to us and be like, “Oh it’s totally fine,” and go forward with it — a structural engineer is a great thing to bring in.
Ashkahn: It usually ends up being that while the float tank is heavy and all the salt water is heavy and all that, it’s just got such a big footprint. The float tanks are so big that the actual amount of pounds per square foot that’s really being put on, is not really as much as one might think. So it tends to be that a lot of buildings can hold it, even the way they are. Especially newer construction, like newer condo type buildings with strong reinforced concrete and stuff like that, tend to not really be much of a concern.
Graham: Again, surprisingly even for older buildings. Often times those are also good to go. Another good reason to consult an expert before spending a lot of money on reinforcements you might not necessarily need.
Ashkahn: Yeah, it’s always weird and there’s always weird stuff out there. I mean, even The Float Shoppe across the river from us, they’re in an old Victorian house and they brought a structural engineer in to check things out before they started and they found they could put float tanks on the second floor but their first floor was not actually strong enough to put float tanks on. Which is really crazy.
Graham: Yeah, so again, consult the experts and if it doesn’t work out, then you always can reinforce anyway.
Ashkahn: Boom.
Graham: Shakalaka.
Recent Podcast Episodes
Are Tankless Water Heaters the Best? – DSP 270
Graham and Jake take on talking about Tankless or “On Demand” water heaters today. They break down a lot of the benefits of them compared to storage water heaters like the fact that they provide a nearly limitless source of hot water, require less energy consumption, etc. They’re not perfect though, and any float center considering one should look closely on how best to implement them. Jake shares some of the pitfalls of them as well as how to maximize their usefulness.
Should Float Centers use Light or Heavy Gauge Studs? – DSP 269
Still no Ashkahn today. He’s taking a couple of post-conference days to himself.
Jake and Graham are on the scene though to answer construction questions, though. Even the straight forward ones, like today. Jake informs us which to choose when doing construction, light or heavy gauge studs when constructing a float center, while getting a little sidetracked when comparing wooden and metal studs.
Construction to Make Your Life Easier – DSP 268
Graham and Jake cover a wide range of construction tips to make running a float center easier. Everything from making sure you have extra storage to installing mop closets with sinks in them for dealing with heavy duty chemicals.
The advice is pretty much a shotgun approach of tips, tricks, and hard lessons learned throughout the years.
Draining Float Tanks into Septic Systems – DSP 267
Graham and Jake tackle the difficulties of draining float tanks and how that process can differ based on different municipalities, different water treatment systems, or whether you’re using a septic system or not.
Water treatment typically involves whole contained ecosystems and highly concentrated epsom salt water can impact that pretty drastically. The guys provide good tips for each type of system and what to be prepared for if you’re operating in a rural area with a septic system.
The Difference Between STC and Decibels – DSP 266
Post-Conference Ashkahn is still out of the recording studio, but fortunately Jake is keeping Graham company in there.
Graham and Jake break down the differences between decibels and STC ratings, two very important to understand when figuring out soundproofing. There’s a lot to digest in this episode, but fortunately the guys keep it easy to understand by providing a broad level overview of the different concepts.
Latest Blog Posts
The Float Tour Blog – Issue #28
Home sweet home! After so many months on the road, it was strange being back here in Portland. We were exhausted, excited, and a little travel weary. The first night back, I slept in my own bed for the first time in three months and the world just melted away.
Having travelled across the United States, I’m reminded of how insular Portland is. We are aggressively fixated on keeping things local. Local beer, ketchup, bikes, pet food, pillows, phone cases… it’s part of our charm. We want to reward people for living here and being a part of the community. It’s so pervasive that, after living here for so long, I kind of forgot that Secret Aardvark hot-sauce isn’t available everywhere, and that most cities don’t even recycle, let alone compost.
The Float Tour Blog – Issue #27
Our northern neighbor – a sister city, of sorts – Seattle is the largest metropolitan area in the Pacific Northwest. It’s the land of Microsoft and Kurt Cobain, and the culture here embraces both simultaneously. It’s tech business professional in the front and rock n’ roll grunge in the back. This blend creates a perfect storm of high energy business life and high energy nightlife, making relaxation a valuable commodity. Floating helps fill the void left by nightmarish traffic and overcrowded restaurants.
Given that it’s so close to home, the float centers in Seattle are a lot more familiar to us. Our visits here were more like a high school reunion than they were like the first day of school. During some of our visits, we were picking up conversations right where we left them.
The Float Tour Blog Issue #26
Vancouver is the largest metropolitan area in Canada, and third largest on the West Coast. It’s a major hub for international trade, with one of the largest ports in the world, giving it a large migrant population, mainly from Asia, the Middle East, and Australia. It’s also been a long-time home to the Canadian film industry, and has even been nicknamed “North Hollywood.” Dozens of film and television productions from major studios film here every year.
Vancouver is very much an international city. It has large boroughs dedicated to varying cultures, including one of the largest Chinatowns in the world. The society here is more receptive to new ideas, always looking for the next big thing; it’s not surprising that floating has blown up in Vancouver as much as it has.
In the last 3 years, 10 float centers have opened up, most of them being larger 4–6 tank centers. The really interesting thing is how they all opened within the same short amount of time about 1 ½ to 2 years ago, within months of each other.
The Float Tour Blog – Issue #25
We finally made it back to the West Coast! We went through the Canadian Rockies and were overwhelmed by the beauty of it all. We drove through hours and hours of winding mountain roads, fertile valleys, and tiny towns so picturesque they looked like movie sets. It was so captivating, in fact, I suspect Graham and Ashkahn may have secretly replaced themselves with robotic doppelgängers to hike throughout Banff.
This post will focus on the smaller communities in B.C. that are bringing floating to new people every day. We also get to visit Canadian manufacturer Pro Float. They’re relatively new to the scene, just opening up earlier this year – another exciting sign of the growth in the industry.
