Something in the world of floating have you stumped?
Show Highlights
Okay, so this is something that happens a lot, and it can seem like a small thing, but it can be a little confusing when it keeps happening. What’s going on when you float in the same tank and keep drifting to one side? How does that happen? And why is it so consistent? Graham and Ashkahn know what the deal is here and drop some knowledge here on this topic.
Listen to Just the Audio
Transcription of this episode… (in case you prefer reading)
Graham: Today’s question is, “is my water out of level? I always float to the same side of my pod. At first I thought it was subtle waves interacting with my symmetry, so I flipped 180 degrees and ended up right back on the same side of the tank.”
Ashkahn: Well … Okay, so water can’t be out of level. It’s naturally leveling. If you put, if you had water in a glass and you tilted your glass in any direction, the top of the water is always going to stay level. It’s liquids.
Graham: Yeah, so physically impossible for your water to be out of level, but I mean I get, so what if it’s, can it affect how waves are generated, or someone’s moving, like the wave machine when they go up on shore, all of a sudden you have cresting little salt waves?
Ashkahn: I’m just thinking on the back of the float tank like generate, like a little wall pushing back and forth, like a wave machine.
Graham: Well you’re kind of the wave generator in this case.
Ashkahn: But the waves would also be level. They’d be on the surface of the water.
Graham: But if it’s tilted to one-
Ashkahn: I don’t know.
Graham: Yeah, I don’t know. Okay, so here’s what I think is going on.
Ashkahn: Here’s what’s happening.
Graham: There are different reasons that you drift to the side of the tank. I do actually think that personal physical asymmetry could very well be one of them, like if your back is really tight, but if you’re turning around and you’re going-
Ashkahn: But that would, you’d have to be like pushing off of something. You contort your body in there.
Graham: Yeah, or just like slightly drifting.
Ashkahn: At the point that you’re still, you can be still in any position and remain still, even if your body was off balance. It’s not going to cause you to drift.
Graham: See I don’t know. When you’re breathing and different things like that, you’re naturally generating small currents inside the water.
Ashkahn: Sure. I just think all that, compared to what we’re about to say is the thing, I think all of this is way, way, way more subtle.
Graham: Okay, what were you … We’ll say what we think it is at the same time.
Ashkahn: Okay.
Graham: All right. Three, two …
Ashkahn: One.
Graham: Okay, I’m just going to do a countdown. Three, two, one. It’s heaters.
Ashkahn: It’s your heaters. It’s probably your heaters is what’s going on here.
Graham: It’s your heaters. You heater is off center or it’s just generating-
Ashkahn: That creates, that can create these kind of like convection currents in the water. If you’re floating in there, and if there’s two heaters in the float tank, or however the heater is set up and installed, the bottom rim, the sides, whatever it is, if those are not on symmetrically, then that’s going to create something that’s going to continuously edge you toward one side of the float tank or the other.
Graham: Yeah, so maybe it’s the physical placement is not quite centered. Maybe if it’s two heaters, one is getting more power than another.
Ashkahn: Or it’s just that the, sometimes two heaters have two separate thermostats and one is reading at a fine temperature and doesn’t think it needs to be turned on, and the other one is reading at a temperature where it does think it needs to be turned on.
Graham: Yup, even if it’s just one solid heater, or built in heating element throughout the tank, that can also just be certain coils and different areas getting hotter than other ones and causing this imbalance too depending on how it’s set up.
Ashkahn: Yeah. My guess is that is probably I think the only thing that would really significantly make you continuously drift to one side of the tank or the other.
Graham: Yup, especially again if it’s the exact same side regardless of orientation or anything else. If you’re always going to the east side of the tank, not like left or right, then I think that’s a good sign that-
Ashkahn: At the point that you’re still, I even think differences in your body and … I don’t know, my breathing pattern I’ve found is not specifically edged me toward anything. For me to really move in the float tank, I have to slightly push off a wall, or in general create some more significant movement.
Graham: See and I’ve talked to people who always go over to the left side of the tank, regardless of whether it’s east or west.
Ashkahn: Of any tank?
Graham: Yes.
Ashkahn: They just always scoot over to the left side?
Graham: Yeah, that’s exactly. I was like, this is the kind of conversation that I had with them.
Ashkahn: Hmm.
Graham: I don’t know.
Ashkahn: I don’t know. All right, well it’s probably the way this person described it.
Graham: Just one of the many things I don’t know about to be fair.
Ashkahn: So check your heaters out. I mean the easiest thing to do is when you’re in the float tank, just put your hands on the bottom or the sides. You’ll be able to feel if the heater is on or not. If you have two heaters, you can put your hands down and you’ll feel one warm and one not. You don’t have to tear your floater tank apart to check this.
Graham: I guess as long as we’re on the subject of heaters and convection currents, it is one reason that I like heaters around the outside of the tank, or even around the inner outside if it’s on the bottom, or something like that. This idea of being able to heat from the sides and push the currents inwards is really a nice idea. As opposed to, on the other side, having one centered heater in the center of the bottom of the tank feels like it’s most likely to generate these currents that hit the top and the center and sort of push off towards the sides in some direction.
Ashkahn: Yeah, it’s an interesting one. I think there’s pros … I find if the tank’s real big and it has heaters only around the side, I can feel it’s warmer as I get closer to the side of a tank than when I’m in the middle as opposed if the heaters are under it. Then all that heat, hot water, is kind of rising out from right under you, which is nice.
Graham: And there’s the ocean float room that just has the entire tub is built in with a heating element.
Ashkahn: Yeah, like a heating grid thing around the whole thing?
Graham: Yeah, exactly. Just kind of heats evenly around the entire tub, which I think helps with things like that.
Ashkahn: Yeah, but having something, just a single strip of heater right directly under you is I guess typically not what float manufacturers do. Usually they’re doing, if it’s on the bottom, they’re kind of putting them slightly out towards the middle so that it does-
Graham: Yeah, but having two of them or something like that instead of just a single one underneath.
Ashkahn: Yeah, it does kind of like help center you, or if it’s around the edges, then that does a better effect of centering you.
Graham: All right.
Ashkahn: Yeah.
Graham: So yeah, water always levels itself.
Ashkahn: That’s the lesson for today.
Graham: All right. If you have any more questions, go to floattanksolutions.com/podcast.
Recent Podcast Episodes
Common Float Tank Issues – DSP 295
Graham and Ashkahn give the skinny on the foibles one my encounter when purchasing a float tank. These aren’t specific to any one manufacturer, but they are useful things to look out for when shopping around for a tank.
What is Float On’s North Star Metric? – DSP 294
Graham and Ashkahn talk about the guiding principles and metrics that dictate how they run Float On and what they measure for success. While they don’t have any float center secrets, they do provide some useful advice in how to look at numbers, when to pay attention to them, and perhaps more importantly, when to ignore them.
What Can you Say About Float Centers Closing? – DSP 293
It happens every once in a while that a center you knew closes down and it can seem like a dark omen for the rest of the industry. The reality is that these are individual circumstances that are brought about not because of a major trend as much as just life events coming up.
Graham and Ashkahn share their take on other float centers closing and what they know about it and how frequently they think it’s occurring.
How to Build a Green Float Center – DSP 292
Graham and Ashkahn talk about the options available for sustainable options when building a float center, or more accurately, the lack thereof. Unfortunately, the materials necessary to make a float room saltproof and waterproof tend to be very unfriendly for the environment.
The guys break down the specific options available and what to consider when adding green technology to your own center.
How We Financed Float On – DSP 291
Graham and Ashkahn are asked about how they financed Float On.
As the guys explain how they started, they go along slight detours to talk about all the mistakes they made along the way and how they’re unsure that Float On could even start today like it did back in 2010. They then go on to explain the pros and cons of the extreme bootstrapping they did to make Float On happen.
Latest Blog Posts
The Heart of Floating – Guest Post by Kevin McCulloch
“When we commit to The Heart of Floating, we form relationships and communities. We share experiences, we connect, we learn, we teach. We care.”
In this guest post, Kevin McCulloch, owner of Float St. Louis and organizer of the Rise: Float Community Gathering, explores the heart of floating and it’s power and potential to connect, heal, and grow individuals, relationships, and communities.
The Most Ambitious Float On Project Yet
We have a new endeavor that we’ve been working on in private for awhile now, and we think that it’s going to make a big splash in our salty little industry. After many years of testing behind closed doors, we’re finally ready to take the plunge and release our secret project to you, the floatation community.
You might want to sit down for this one….
The Start-a-Center Giveaway Returns!
Everyone knows that, when it comes to gifts, it’s much more fun to give than to receive. With this year’s Start-a-Center Giveaway, however, I’m not so sure anymore. With over $13,000 in Float Tank Solutions products going to one lucky duck (plus $4,000 worth of goodies from other float industry homies), we humbly suggest that we may have finally tipped the scales in favor of the recipient.
If you’re Charlie, this Giveaway is the Golden Ticket, which I guess makes the Construction Package a Wonka bar and the Ninja Fans are the Fizzy Lifting Drink. So, what do you have to do for a chance at all the Everlasting Gobstoppers?
It’s been three years since our last Giveaway, and we thought that it was long overdue for another one. So, what’s the dealio? The Giveaway is a chance to give a big ol’ boost to a deserving Float-Center-To-Be. This time around, we’re taking things to a whole new level, with over three times the value of products and services being given away. To you. For free.
Dear Everyone: Please reconsider building your own tanks
Look, we get it. Really. Float tanks are expensive – especially for what can seem, from the outside, like a glorified bathtub with spa parts attached. It doesn’t take long to go from, “Why is this so expensive?” to “I’ll bet I could save money by making my own tank!” After you start mulling it over, you get excited. You could be offering something no one else does right now… because it’d be your own creation! How hard can it possibly be?
As experts in only thinking about half of the consequences of our actions (at best), we’d like to say, “Incredibly hard, actually!”
