Something in the world of floating have you stumped?
Show Highlights
Okay, so this is something that happens a lot, and it can seem like a small thing, but it can be a little confusing when it keeps happening. What’s going on when you float in the same tank and keep drifting to one side? How does that happen? And why is it so consistent? Graham and Ashkahn know what the deal is here and drop some knowledge here on this topic.
Listen to Just the Audio
Transcription of this episode… (in case you prefer reading)
Graham: Today’s question is, “is my water out of level? I always float to the same side of my pod. At first I thought it was subtle waves interacting with my symmetry, so I flipped 180 degrees and ended up right back on the same side of the tank.”
Ashkahn: Well … Okay, so water can’t be out of level. It’s naturally leveling. If you put, if you had water in a glass and you tilted your glass in any direction, the top of the water is always going to stay level. It’s liquids.
Graham: Yeah, so physically impossible for your water to be out of level, but I mean I get, so what if it’s, can it affect how waves are generated, or someone’s moving, like the wave machine when they go up on shore, all of a sudden you have cresting little salt waves?
Ashkahn: I’m just thinking on the back of the float tank like generate, like a little wall pushing back and forth, like a wave machine.
Graham: Well you’re kind of the wave generator in this case.
Ashkahn: But the waves would also be level. They’d be on the surface of the water.
Graham: But if it’s tilted to one-
Ashkahn: I don’t know.
Graham: Yeah, I don’t know. Okay, so here’s what I think is going on.
Ashkahn: Here’s what’s happening.
Graham: There are different reasons that you drift to the side of the tank. I do actually think that personal physical asymmetry could very well be one of them, like if your back is really tight, but if you’re turning around and you’re going-
Ashkahn: But that would, you’d have to be like pushing off of something. You contort your body in there.
Graham: Yeah, or just like slightly drifting.
Ashkahn: At the point that you’re still, you can be still in any position and remain still, even if your body was off balance. It’s not going to cause you to drift.
Graham: See I don’t know. When you’re breathing and different things like that, you’re naturally generating small currents inside the water.
Ashkahn: Sure. I just think all that, compared to what we’re about to say is the thing, I think all of this is way, way, way more subtle.
Graham: Okay, what were you … We’ll say what we think it is at the same time.
Ashkahn: Okay.
Graham: All right. Three, two …
Ashkahn: One.
Graham: Okay, I’m just going to do a countdown. Three, two, one. It’s heaters.
Ashkahn: It’s your heaters. It’s probably your heaters is what’s going on here.
Graham: It’s your heaters. You heater is off center or it’s just generating-
Ashkahn: That creates, that can create these kind of like convection currents in the water. If you’re floating in there, and if there’s two heaters in the float tank, or however the heater is set up and installed, the bottom rim, the sides, whatever it is, if those are not on symmetrically, then that’s going to create something that’s going to continuously edge you toward one side of the float tank or the other.
Graham: Yeah, so maybe it’s the physical placement is not quite centered. Maybe if it’s two heaters, one is getting more power than another.
Ashkahn: Or it’s just that the, sometimes two heaters have two separate thermostats and one is reading at a fine temperature and doesn’t think it needs to be turned on, and the other one is reading at a temperature where it does think it needs to be turned on.
Graham: Yup, even if it’s just one solid heater, or built in heating element throughout the tank, that can also just be certain coils and different areas getting hotter than other ones and causing this imbalance too depending on how it’s set up.
Ashkahn: Yeah. My guess is that is probably I think the only thing that would really significantly make you continuously drift to one side of the tank or the other.
Graham: Yup, especially again if it’s the exact same side regardless of orientation or anything else. If you’re always going to the east side of the tank, not like left or right, then I think that’s a good sign that-
Ashkahn: At the point that you’re still, I even think differences in your body and … I don’t know, my breathing pattern I’ve found is not specifically edged me toward anything. For me to really move in the float tank, I have to slightly push off a wall, or in general create some more significant movement.
Graham: See and I’ve talked to people who always go over to the left side of the tank, regardless of whether it’s east or west.
Ashkahn: Of any tank?
Graham: Yes.
Ashkahn: They just always scoot over to the left side?
Graham: Yeah, that’s exactly. I was like, this is the kind of conversation that I had with them.
Ashkahn: Hmm.
Graham: I don’t know.
Ashkahn: I don’t know. All right, well it’s probably the way this person described it.
Graham: Just one of the many things I don’t know about to be fair.
Ashkahn: So check your heaters out. I mean the easiest thing to do is when you’re in the float tank, just put your hands on the bottom or the sides. You’ll be able to feel if the heater is on or not. If you have two heaters, you can put your hands down and you’ll feel one warm and one not. You don’t have to tear your floater tank apart to check this.
Graham: I guess as long as we’re on the subject of heaters and convection currents, it is one reason that I like heaters around the outside of the tank, or even around the inner outside if it’s on the bottom, or something like that. This idea of being able to heat from the sides and push the currents inwards is really a nice idea. As opposed to, on the other side, having one centered heater in the center of the bottom of the tank feels like it’s most likely to generate these currents that hit the top and the center and sort of push off towards the sides in some direction.
Ashkahn: Yeah, it’s an interesting one. I think there’s pros … I find if the tank’s real big and it has heaters only around the side, I can feel it’s warmer as I get closer to the side of a tank than when I’m in the middle as opposed if the heaters are under it. Then all that heat, hot water, is kind of rising out from right under you, which is nice.
Graham: And there’s the ocean float room that just has the entire tub is built in with a heating element.
Ashkahn: Yeah, like a heating grid thing around the whole thing?
Graham: Yeah, exactly. Just kind of heats evenly around the entire tub, which I think helps with things like that.
Ashkahn: Yeah, but having something, just a single strip of heater right directly under you is I guess typically not what float manufacturers do. Usually they’re doing, if it’s on the bottom, they’re kind of putting them slightly out towards the middle so that it does-
Graham: Yeah, but having two of them or something like that instead of just a single one underneath.
Ashkahn: Yeah, it does kind of like help center you, or if it’s around the edges, then that does a better effect of centering you.
Graham: All right.
Ashkahn: Yeah.
Graham: So yeah, water always levels itself.
Ashkahn: That’s the lesson for today.
Graham: All right. If you have any more questions, go to floattanksolutions.com/podcast.
Recent Podcast Episodes
How Often Does Float On Party? – DSP 225
Ashkahn and Graham have developed a bit of a reputation over the years within the industry as party animals. Anyone who has met them can confirm this to be true. But how often to the throw parties at Float On? What are good occasions for float center parties and how do you throw one?
The guys share their party philosophy and offer some nice tips and tricks for throwing a sensory deprivation shindig.
Is there a “Best” Float Position? – DSP 224
Ashkahn and Graham thoroughly debunk the myth of a “best” float position. The Float On boys explicate their philosophy that there is no right way to float and instead talk about all the different positions they enjoy floating in. They learn more about each other than they expected to in the process.
What to Look for When Hiring a Float Center Employee – DSP 223
What makes a good float center employee? What does Float On look for when trying to find someone to take care of their salt monster tanks and their blissed out customers at the same time?
Ashkahn and Graham break down the qualities they look for when hiring, and what makes the people at Float On so special.
How Do you Incentivize Return Floaters without Memberships or Packages? – DSP 222
How many times has a float center owner had a first time floater come out of the tank and said something along the lines of “that was amazing! I need to do this every week!” and then they never see that person again? How do you get them to come back without committing to a membership or a high ticket package of floats?
Ashkahn and Graham share their thoughts on this exact problems and some of the creative solutions they’ve implemented at Float On to combat it. The key, for them, has been keeping it simple and making it accessible.
How to Schedule Your Float Center During the Slow Season – DSP 221
For most float centers, the summer months drastically change how busy it gets. It seems that zenning out to nothingness is moderately less appealing when there’s a lot of outdoor activities to enjoy.
Graham and Ashkahn share their thoughts on a reduced schedule. Float On runs 24 hours almost every day throughout the year. so reducing their schedule is typically against their philosophies. They explain some of the reasons people might consider it, what are some good ways to go about it, as well as explain some practices to consider avoiding when cutting hours.
Latest Blog Posts
Float Quarterly – January 2016
It’s been our pleasure to be actively involved in the float industry for over five years now. In 2016, we’re already on track to have more new centers opening, more press covering floating, and more resources for people just entering our salty world than ever before.
With so much action, we’ve decided to send out brief, quarterly updates on our industry to keep people posted on the all the latest happenings. Welcome to our first installment!
Training to Become a Certified Pool/Spa Operator
Each year at the Float Conference, we put on a Certified Pool/Spa Operator (CPO) training course. At first, that might strike you as an odd thing to have as part of a float tank conference. This post will explain what CPO training is and why we think it can be a really useful certification to have on your belt.
Increase Sales by Offering Retail in Your Float Center
On their own, float tanks have a limit to their profits. Retailing has the potential to bring extra money into your shop, but it also requires a lot of work and attention on your part to really be successful at it. At Float On, our retail contributes 6.5% towards our overall sales and 3% of total profit. While this might not seem like a large contribution, depending on your sales, it could end up paying the wages of a whole extra employee.
The Health Department and Float Tanks… How to get Approved!
If you’re working on starting a float center, chances are you’re nervously anticipating having to call the health department. We’ve all heard horror stories of people being asked to follow pool rules that don’t make sense for them, or having to do costly changes to their pump systems.
float tanks not regulatedBelow is our best advice for working with your health department to get your float center approved, but before we dive into that, it’s important to get a bit of an understanding as to how the health department works.
