These are challenging times for all of us, and many float centers (ourselves included) have decided to temporarily shut down to help stop the spread of coronavirus. Our team got together yesterday to figure out what we need to do to put our shop into hibernation mode, and we thought we’d share the list we came up with to help out anyone else who is in a similar position.
Best of luck to everyone going through this. We know we’ve seen a wellspring of kind words and support from our community when we decided to shut down, and we’re sure you have too. It’s nice to know the float world will be supported when we’re all on the other end of this.
Of course, if there’s anything that you’ve done in your own closure that you don’t see here, please send it along and we’ll update this list as suggestions come in.
Float Tank Solutions
Shop Hibernation Checklist
After the last float
- Do a full cleaning and disinfection pass across your center.
- Deal with your mail and package deliveries. You may need to put up a sign for your mail person, stop your mail from being delivered, or attempt to cancel or reroute any packages that are already on their way.
- Stop any automatic deliveries you have for any shop supplies.
- Make sure your HVAC system is set to run the whole time.
- Remove any food and beverages that can’t be stored for longer periods of time.
- Remove cash and any other valuables.
- Forward incoming calls and set up an appropriate voicemail (make a task to change the forwarding and voicemail when you re-open)
- Put bleach into washer and dishwasher and run them, then leave doors slightly open
- Consider putting out ant traps, if it’s appropriate for your area
Daily Ongoing Maintenance
- If your float tank doesn’t automatically run your pumps, go in twice a day to run them. This will both provide your float solution with its cleaning cycle, and prevent any salt crystallization from happening inside of your pipes and filtration equipment. Make sure to open the doors on your float tanks to let them air out while you’re there.
- Balance any levels of chemical treatment that you use (like hydrogen peroxide)
- Run the showers once a day to prevent any sort of buildup in the pipes
- Make sure to put water down all of your floor drains to keep your p-traps filled (so you don’t get sewer gas coming out)
- Empty your dehumidifiers (if you have any)
- Consider leaving some lobby lights on to deter vandalism
- Clean up any garbage outside the shop. It’ll help keep your city looking nice, and will also help deter vandalism.
- Answer voicemails
- Answer emails
- Answer social media inquires
- Collect physical mail
- Water any plants you may have (or take them to your house).
Weekly Ongoing Maintenance
- Replenish any water in your tanks that has been lost to evaporation (you may need to add a little salt as well).
- Do a disinfection pass on the inside of your tank walls and ceiling. It’s still a very hot and humid environment, and you want to make sure you’re preventing any mold growth.
There are, of course, other things to consider like communication with your customers and taking care of your members. You may be looking at laying off part, or all, of your staff temporarily so they can claim unemployment benefits. The next couple weeks are also going to be a good time to work on your marketing, to make sure that your customers are ready to float when you re-open.
We’re keeping the list above to just the operational side of things for now, but we’ll be releasing more over the coming days and weeks about what we’re doing at Float On to get through this.
Stay well,
Graham and Ashkahn
Should Float Centers use Light or Heavy Gauge Studs? – DSP 269
Still no Ashkahn today. He’s taking a couple of post-conference days to himself.
Jake and Graham are on the scene though to answer construction questions, though. Even the straight forward ones, like today. Jake informs us which to choose when doing construction, light or heavy gauge studs when constructing a float center, while getting a little sidetracked when comparing wooden and metal studs.
Construction to Make Your Life Easier – DSP 268
Graham and Jake cover a wide range of construction tips to make running a float center easier. Everything from making sure you have extra storage to installing mop closets with sinks in them for dealing with heavy duty chemicals.
The advice is pretty much a shotgun approach of tips, tricks, and hard lessons learned throughout the years.
Draining Float Tanks into Septic Systems – DSP 267
Graham and Jake tackle the difficulties of draining float tanks and how that process can differ based on different municipalities, different water treatment systems, or whether you’re using a septic system or not.
Water treatment typically involves whole contained ecosystems and highly concentrated epsom salt water can impact that pretty drastically. The guys provide good tips for each type of system and what to be prepared for if you’re operating in a rural area with a septic system.
The Difference Between STC and Decibels – DSP 266
Post-Conference Ashkahn is still out of the recording studio, but fortunately Jake is keeping Graham company in there.
Graham and Jake break down the differences between decibels and STC ratings, two very important to understand when figuring out soundproofing. There’s a lot to digest in this episode, but fortunately the guys keep it easy to understand by providing a broad level overview of the different concepts.
Should I Wire my Float Tanks into the Wall? – DSP 265
Ashkahn is currently recovering from his talk and the after-party last night, but Jake and Graham have gracefully taken the time to answer a construction question again today.
On the docket today is a question about wiring a float tank directly into the wall. Graham and Jake provide an overview of why some people may prefer this (it’s much easier to keep waterproof, e.g.), and why at Float On they use the twist lock for their outlets and how to properly utilize them.
Can I Keep My Old Ceiling With My Buildout? – DSP 264
Hopefully everyone had a lovely time at the Friday Activities and the after-party.
Ashkahn is still busy running the conference, but Graham and Jake have stepped in to talk about construction!
Today the guys talk about keeping a drop ceiling or T-bar ceiling in an existing space that you’re converting to a float center. The short answer is don’t keep it, as it can cause problems, but the guys do have some workarounds if your landlord is opposed to changing the ceiling.
What to Expect When Expanding from 1 to 3 Tanks? – DSP 263
Ashkahn is busy preparing for everything that happens tonight and tomorrow for the Conference, but that doesn’t mean Daily Solutions will stop being daily.
Graham and Jake talk construction and what to expect when you’re expecting… a giant expansion for your float center. What’s it look like when you go from one tank to three? How do the demands change? What needs to be put in place to make sure that you’re not hitting snags?
Fortunately, these guys know the score and are happy to share.
All About Floor Drains – DSP 262
As Ashkahn gets everything ready for the Start a Center Workshop (happening today) and the Float Conference this weekend, Graham and Jake tackle answering construction questions on the podcast.
Today they’re talking about floor drains. What to consider for drains and how they might pair with different types of flooring. Given the hefty price tag for these more advanced drains, having as much research before making a decision on these is essential. Luckily, the guys have done the hard part already and identified a lot of things to consider.
How to Deal with Float Room Humidity – DSP 261
Graham and Jake are at the helm again while Ashkahn puts the finishing touches on the Float Conference.
Today, the guys are talking all about humidity and how to deal with it when constructing your float rooms. They talk about all the little nuances that you (or your contractor) might not think about when it comes to humidity and how soundproofing and regular airflow may not always go hand in hand.
Long Term Construction for Float Centers – DSP 260
Ashkahn is still gone, getting ready for the Float Conference. The festivities kick up this week, and he’s busy working diligently to make all our dreams a reality.
In the meantime, Jake and Graham tackle the notion of ongoing maintenance and the ever evolving nature of a float center. Jake sets the record straight on the concept of having a “finished” float center, as new problems always arise. It’s not all bad news, though, as these changes allow for new opportunities for your centers.
