Looking for something specific?
Search our nearly 100 blog posts.
Float On has been around for nearly 9 years, and in those 9 years, we’ve gone through lots of floors. Some have held up better than others. Some didn’t hold up at all. At one point we tried putting down textured pebbles with epoxy grout, pebbles that turned to putty within a few months. Lessons about flooring are the kind of lessons you learn quickly. Each time you replace your floors, it means hours of tearing out existing floors, working around plumbing, hours and hours of downtime (in our case for the entire shop, given how small it is).
Throughout the years, we’ve tried lots of floors. We’ve learned from our mistakes and seen the mistakes of others and learned from those too!
We’ve collected a few tactics that have helped ourselves – and others – pick out the best floors for a variety of different scenarios. Fortunately, we’ve written everything down so you don’t even need to take notes!
Let’s start with how we protect our floors from falling apart.
First off, we choose the right waterproofing (and salt-proofing) material and remain ever vigilant about preventative maintenance.
Not only did we inspect every single seam and potential weak spot upon initial installation of our floors, we continue to crawl around and check every last one for damage during deep cleans each week. When any small installation imperfection or random pinhole can lead to catastrophic failure, it pays to stay en garde.
Float tank center floors endure a constant barrage of saltwater, repetitive scrubbing, and high foot traffic. They must remain slip-resistant when drenched with silky smooth float tank water and, preferably, look stylish while doing so.
It’s much easier to flush salt water down a floor drain than it is to mop it up. So put floor drains everywhere. Obviously, you’ll need a floor drain in your shower area. We also like to install one near the dressing area and another one near the spa pack of the float tank. It’s a lot nicer to discover a salty leak that’s trickling down a floor drain instead of one that’s pooling in the middle of your float room.
Slip-resistant vinyl flooring is an excellent option for a float tank room, especially for hardwood floors. With heat-welded seams and the installation of surface-level membrane clamping floor drains, vinyl flooring has the potential to protect your substrate for years to come. We have noticed that hard-soled shoes definitely have an impact on the appearance of vinyl sheet flooring over the years. We’ve also noticed that it can become brittle where the material is coved up the wall in a float room.
Epoxy resin is another excellent option for protective flooring in a float tank room. Epoxy resin is rigid and can crack if your substrate is flexible like a wood floor. You will need to add something to the resin for slip resistance, though. There are many fine options including glass beads, aluminum oxide, and our personal favorite: multicolored quartz. It’s like sand art on your floors!
It’s important to pay special attention to the bond between the resin flooring and the edge of the drain body. Talented installers will “key in” the resin around the floor drain. This means grinding a very narrow/shallow trough around the drain and letting the first pour of epoxy fill the trough. Sometimes, installers will even use heat to disperse any small bubbles within the resin.
Porcelain tile and epoxy grout is another option for flooring within a float room. It’s not our first choice, though. The tiles tend to be a little slippery. We often see float centers use interlocking rubber mats to provide slip resistance in these situations.
Even with the best-constructed floor, it’s not going to matter if you don’t maintain it. Keep an eye out for damage as time goes on. Flooring is one of those areas where small problems become large problems very quickly. Being proactive can save you money, not just on materials, but on downtime with float rooms, as smaller fixes take less time to repair.
If you’d like a detailed guide on our best practices for floors as well as your entire float center construction build-out, check out our complete Float Center Construction Package. Literally hundreds of pages written and reviewed by the best electricians, flooring experts, contractors, sound-proofers, and float center owns in the industry.
The Float Tour Blog – Issue #27
Our northern neighbor – a sister city, of sorts – Seattle is the largest metropolitan area in the Pacific Northwest. It’s the land of Microsoft and Kurt Cobain, and the culture here embraces both simultaneously. It’s tech business professional in the front and rock n’ roll grunge in the back. This blend creates a perfect storm of high energy business life and high energy nightlife, making relaxation a valuable commodity. Floating helps fill the void left by nightmarish traffic and overcrowded restaurants.
Given that it’s so close to home, the float centers in Seattle are a lot more familiar to us. Our visits here were more like a high school reunion than they were like the first day of school. During some of our visits, we were picking up conversations right where we left them.
The Float Tour Blog Issue #26
Vancouver is the largest metropolitan area in Canada, and third largest on the West Coast. It’s a major hub for international trade, with one of the largest ports in the world, giving it a large migrant population, mainly from Asia, the Middle East, and Australia. It’s also been a long-time home to the Canadian film industry, and has even been nicknamed “North Hollywood.” Dozens of film and television productions from major studios film here every year.
Vancouver is very much an international city. It has large boroughs dedicated to varying cultures, including one of the largest Chinatowns in the world. The society here is more receptive to new ideas, always looking for the next big thing; it’s not surprising that floating has blown up in Vancouver as much as it has.
In the last 3 years, 10 float centers have opened up, most of them being larger 4–6 tank centers. The really interesting thing is how they all opened within the same short amount of time about 1 ½ to 2 years ago, within months of each other.
The Float Tour Blog – Issue #25
We finally made it back to the West Coast! We went through the Canadian Rockies and were overwhelmed by the beauty of it all. We drove through hours and hours of winding mountain roads, fertile valleys, and tiny towns so picturesque they looked like movie sets. It was so captivating, in fact, I suspect Graham and Ashkahn may have secretly replaced themselves with robotic doppelgängers to hike throughout Banff.
This post will focus on the smaller communities in B.C. that are bringing floating to new people every day. We also get to visit Canadian manufacturer Pro Float. They’re relatively new to the scene, just opening up earlier this year – another exciting sign of the growth in the industry.
The Float Tour Blog – Issue #24
Alberta is often called the Texas of Canada. Part large oil industry, part cattle country.
Don’t Mess With Alberta!
At the base of the Rocky Mountains, replete with an Olympic Stadium, Calgary is a world-class destination for winter sports. The float community developed here similarly to Edmonton – there wasn’t anything nearby except for one or two residential float tanks, and then, in a short period of time, several centers opened all at once. Instead of competing, they’ve decided to work together and have developed one of the tightest knit float communities we’ve seen. They even have monthly Float Dinners, much like we do with the float centers in Portland. They don’t keep meeting minutes, so it’s hard to determine what they talk about at these dinners; my guess would be salt, the effects of salt on various substances, and how salty salt damage can make someone salty.
The Float Tour Blog – Issue #23
After Montana, we blazed our way back into Canada. The drive was long, but the scenery was beautiful. We followed the Rockies north, driving up to Edmonton. It’s a bit of a detour but, there are so many float centers in Edmonton, it seemed crazy not to stop by.
The city itself is primarily made up of workers from the oil fields – high risk, high income jobs that fuel the economy. At least until recently. Our visit was right in the middle of the Fort McMurray wildfire which has displaced a lot of the workforce, forcing 100,000 people to leave their homes. Many came to Edmonton, being the nearest metropolitan area to Fort McMurray. Some already split their time between the two cities, living in Edmonton and traveling to Fort McMurray for weeks or months at a time for work.
It’s understood that, in economic hardship, luxury commodities are typically the first thing people cut back on. Surprisingly, this doesn’t seem to be the case for floating. In fact, more people seem to be trying it to help alleviate the stress, many centers even offering free or discounted services to those displaced in an effort to help in a small way.
The Float Tour Blog – Issue #22
We’ve got two more stops in Colorado Springs before heading west. It’s a town known for its military base and long history of weapons testing. With such a large military presence, it comes as no surprise that the float center owners here are veterans, themselves.
After that, we shoot across to Salt Lake City. Utah is filled with gorgeous sights, from breathtaking lakes to stunning painted hills. With an international landmark famous for its effects on buoyancy, Salt Lake City should be pretty familiar with the concept of floating. With five different float centers, and the manufacturer of the Zen Tent out there, there could be some cause and effect.
After that, we head up into Idaho and Montana to close out the Central United States portion of our Tour. We’ll follow the Rocky Mountains north, taking in the scenery along the way.
The Float Tour Blog – Issue #21
Denver has been home to a vibrant float community for a long time. Some of the earliest commercial centers that started up in the ‘70s and ‘80s were out here. 30 years is a long time, and most of the old centers aren’t around anymore, but there’s a conscious community that has been floating since the old days and they love how much the industry has evolved and grown.
The Float Tour Blog – Issue #20
We now follow the trail of our ancestors, Meriwether Lewis & William Clark, whose expedition started in St. Louis and would, eventually, lead them to Oregon – just like us.
Except, unlike them, we didn’t actually start in St. Louis, don’t have a tour guide from the Lemhi Shoshone tribe, and aren’t carrying flintlocks (except for Graham).
The Float Tour Blog – Issue #19
Chicago is home to one of the oldest float centers still in operation – SpaceTime Float Tanks.
We had the misfortune of timing our visit as they were moving to a larger location, the only time in 34 years that they have ever been closed. It is with great regret that we were unable to see their historic float center in operation.
They were trailblazers even before there were trails to blaze – so many float centers in the entire Midwest trace their roots back to a single float at SpaceTime.
The Float Tour Blog – Issue #18
We made it back to America, everybody. It was a harrowing experience being in an uncivilized country where they think gravy and cheese curds on french fries is a meal but, thankfully, we’ve crossed the border back to a country where we know that chili and shredded cheese on french fries is a meal. Civilization.
Quite honestly, we might be in love with Canada. We’re definitely making another trip up there. For now, it’s about to MPH not KPH.