Learn best practices for starting and running a float center:
  • This field is for validation purposes and should be left unchanged.

Something in the world of floating have you stumped?

  • This field is for validation purposes and should be left unchanged.

Show Highlights

Is it better to plan out your center for one float tank and build out from there, or should you future-proof your design in case you want to expand? Graham and Ashkahn break down the logistical issues of planning out both and the reasons someone might decide to go one way over another. Construction costs, hiring specialists, and shipping costs are all things to consider when making a decision like this and it can be expensive either way. There are smart ways to build out a center while saving up to expand later, and Graham and Ashkahn make a point to give advice about that as well.

Listen to Just the Audio

Transcription of this episode… (in case you prefer reading)

Graham: Today’s question for us is, “did you begin with only one tank? Did you pick a location for multiple tanks? It seems as though the construction/moving process would make you lean towards a larger location if that’s what you’re going for.”

I say “multiple tanks” is what they mean by “if that’s what you’re going for”. Not like if you’re going for a larger location, then you should definitely get one, because that’s pretty self-evident.

Ashkahn: That’s pretty obvious. Hard not to do that.

Graham: So no.

Ashkahn: Did we start with one tank? No.

Graham: No, we started with four tanks.

Ashkahn: Yeah, but we do advise people to start with one tank. In their house, not build your center out for one tank.

Graham: I see, yeah. So we kind of advise the opposite in terms of actually building a designated float center.

Ashkahn: Yeah, yeah.

Graham: If someone says, “Should I have a one-tank center or four-tank center?” Usually we say four tanks.

Ashkahn: I’m thinking maybe that’s what they … Maybe they heard that we say stuff like, “Start out with a single float tank,” you know?

Graham: In your house.

Ashkahn: Right.

Graham: Just to bring some people in, learn the ropes, and then when you move to your bigger float center …

Ashkahn: An actual … Like when you’re leaving your house.

Graham: Then, you can use that tank in that center and add it to your three other units, or whatever it is.

Ashkahn: Or you could sell it.

Graham: And get out of the industry altogether, yes. And just leave.

Ashkahn: Move out of your house.

Graham: Once you realize how much salt cleaning there is, yeah. And that is one of the reasons I say people should get a float tank in their house when I’m pitching it. It’s like you may decide you hate this.

So, no we didn’t start with one tank, but the idea of launching a float center with fewer tanks and later expanding in that same location to more tanks is also something that we advise people to do.

Ashkahn: Yeah, basically, it’s expensive to start up a float center.

Graham: Yeah.

Ashkahn: And rather than cutting corners on all of your construction, we usually recommend people save money by maybe not launching with the full amount of tanks they want and saving money on, first of all, the purchasing of those extra float tanks. And there’s some of the room construction that you don’t really need to do until the point that you actually want to put float tanks in there. And there’s some that you want to do in your normal round of construction too.

Graham: Yep. So basically, what happens here is that as much construction as you can get done all at the same time, even if you’re not launching with all your float tank rooms … Let’s just say that you’re starting with two tanks, you have room for five rooms. In a totally ideal world, you’d actually build out the entirety of those five rooms and just not put the float tanks in, essentially. And that’s because every time you have a contractor come out, there’s a certain amount of money just to get them on the jobsite to get the contract signed, to start construction, and to do whatever work is going to be done.

So as much as you have done at one time, it’s going to make each room that much cheaper for every room that’s added on, right? In that sense, a single room is the most expensive thing to build, so if you build out a float tank room in your hypothetical five-tank center, and that’s all you do? Then next time you’re going to have to call in all the soundproofers, you’re going to have to call in the plumbers, you’re going to have to call in the waterproofers, and they’re going to have to build a second room. And the third time, repeat that process over and over. Every time you’re calling them out, you’re kinda paying a premium to get them out there to begin with.

So the more work you can get done all at once for any of your construction is, of course, better.

Ashkahn: Right. It goes with float tanks too. You’ll probably save on some shipping cost, and if someone’s coming out to install them and all that sort of stuff.

Graham: Yeah, for sure. Just getting all your float tanks at once is definitely the ideal.

Ashkahn: But it does scale back, so there’s certain things like, obviously, your float tanks would be the first thing to go if you were trying to consider not building a room out fully. You don’t want to just buy float tanks and then put them in storage. That would be really silly.

And then from there, it would probably be your waterproofing because all that is a layer that goes on top of stuff. So if you build a room out and then later you bring someone in to actually put in the kind of floors you’re looking for, or maybe you put the floors in already but you want to put up wall paneling, or something like that, that’s kind of a layer that can be just added on top of the existing construction you did.

Graham: Though we do see some centers, it’s really funny going into a place … Just to back up slightly, a lot of people use these extra rooms for storage.

Ashkahn: Massage.

Graham: Yeah, practitioner rooms so they can rent it out in the meantime, and it’s really funny to go into a massage room that has fully waterproof floors, and drains, and an actual shower fixture. It’s really obvious it’s going to be a float tank room as soon as they can afford the tank to actually put in there, but in the meantime there’s a massage table, and some nice ambient lighting, and things like that. So that is a funny experience.

Ashkahn: And then soundproofing is way harder to not do at first because ideally … It’s not like soundproofing is just something you add on top of non-soundproof material. You’re usually either buying normal building material or soundproof building material when it comes to things like sheetrock, or doors, or stuff like that. So you could save money. You could build double-stud walls and then put normal sheetrock on top of them, and then tear that sheetrock out and replace it with soundproof sheet rock, but that starts to get more and more difficult. And you’re starting to spend more money on temporary things when you’re getting to that point.

Graham: Although extra layers can also be a place to cut corners, so if you could just put a single layer of soundproof drywall or of your soundproofing wall assembly and then later, before you’re adding on all the waterproofing, you know that you’re going to go on and add that whole second layer of walling? That’s doable. You are only wasting the money for mudding and painting and stuff like that.

Ashkahn: And then, pretty much plumbing is where I would really draw the line. You really don’t want to have to … In the middle of wanting to add more rooms bring out someone to cut trenches in your concrete and lay more plumbing lines. It just gets crazy from that point.

Graham: Absolutely, rough in the plumbing.

Ashkahn: And electrical, too.

Graham: So if you are planning to have five tanks, you’re building out two of your rooms totally, immediately, still plumb out the other three rooms. Rough it in. You know, you won’t have to cut in the concrete when you do install your next float tanks. All you have to do is get the plumbers back in there. They can install the fixtures and you are pretty much good to go on the plumbing side.

Ashkahn: Yeah, the stuff that’s really going into the infrastructure of your building: plumbing, electrical, that sort of stuff.

Graham: Even planning for HVAC because the entire system will be load balanced in an HVAC system as well. So knowing where your rooms are going and what you are planning is actually going to be a really important part of getting that accurate.

Ashkahn: That’d be the stuff that’d be really expensive and a huge headache to have to add that in after the fact.

Graham: And with electrical, we’ve done that before, too. Had to go back in and cut into our ceilings and run electrical lines all the way across the course of our entire center in order to tie back in to the electrical box to go into new rooms and add new circuits. That’s so much more expensive than doing the electrical work at the beginning when your space is gutted and you can just get inside the walls and inside the ceiling. Anytime you have to cut back into your construction to add something in is just so painful and more expensive.

Ashkahn: Yeah and not having a big enough breaker box or something. You didn’t really plan for anything sort of scenario. That stuff can really just start to add up.

Graham: Yep. That’s kinda the essentials. And you’re right, as a result of how crazy all this construction is and how expensive it is, this is still the preferred way to do it. The idea of getting a center, building out for two tanks and then later, moving to a place where you could fit all five tanks into means you are kinda losing all of the construction cost going into the rooms for those first two tanks. You can’t really bring the waterproofing or the soundproofing or the plumbing work with you at all into the next location. So that’s why you see so many centers building out –  If they don’t have enough money to start with as many rooms as they want initially – you do see them adding those tanks on to the same existing center they’ve already built the first rooms in.

Ashkahn: Then, you just have extra rooms to play with. Turn them into a ball pit or …

Graham: An extra-large ball pit

Ashkahn: Tiny ball pit. There’s all sort of different variations on ball pit that you could use for those different rooms you have.

Graham: And Google is a great place to do more research on that.

Ashkahn: Maybe we should just have … There needs to be an episode about that, I think. Have to dive into it.

Graham: Yeah, I’ll make …

Ashkahn: You got that?

Graham: You got that written down? Yeah, our sound guy has that written down. We’re on top of that. Alright.

Ashkahn: I think that sounds like we have answered this question.

Graham: If you have anymore questions for us, go to FloatTankSolutions.com/podcast.

Recent Podcast Episodes

How Often Should I Post on my Float Center’s Social Media? – DSP 190

On the second day of social media week, Ashkahn and Graham ask Derek how often float centers should post as well as what makes good content. 

Derek lays out practical tips for how to schedule your social media (DON’T AUTOMATE), as well as what makes a good post. Facebook has several algorithms to limit your reach depending on the post so it’s important to avoid certain keywords and post topics to reach the broadest audience without paying for it.

What are “Good” Social Media Numbers for Float Centers? – DSP 189

Not everyone is a social media wizard, but fortunately for Social Media Week, Derek is here to answer all the questions the float industry might have, from the obvious to the obscure.

In this episode, Derek, Graham, and Ashkahn discuss what it means to have good social media engagement. The effect of things like Facebook likes, reacts to posts, and how to cultivate those. 

Can you Float During a Lightning Storm? – DSP 188

Certain areas are prone to particular natural events. Some more terrifying for float centers than others. Lightning storms come to mind. Because water is conductive and the last thing you want in your float tanks are electrocuted customers.

So, is it a bad idea to float during lightning storms or does it even matter? Graham and Ashkahn weigh in with a heavy dose of skepticism and repeated calls to consult with a professional electrician before making any big decisions. 

How to Choose the Perfect Float Tank – DSP 187

One of the biggest decisions you have to make for your float center is what tank to choose. This is what your business is based around. So how do you go about making this decision? A lot of newer float center owners want to know what the “Best Tank” is. The reality is that there isn’t some clear front runner in float tank quality. Every tank has it’s strengths and weaknesses. It really depends on what you’re looking for and what you want to spend. 
Graham and Ashkahn share what they think are the most important things to consider when choosing your float tank. 

How to get Building Plans Before you Have a Building? – DSP 186

Often times banks will want your building plans to approve your business loan, but you can’t purchase a building before the loan is approved. Sometimes health departments will want to know which tanks you’ll get before they’ll approve your business which can also hold up your bank loan. It feels like a Catch-22 and has definitely infuriated plenty of float center owners just starting out. 

Graham and Ashkahn lay out the confusing battle you’ll have to take on to get your business started and the ways in which you can get approved, plus the silver linings these extra hoops can offer you.

Latest Blog Posts

Empty Float Tanks and What to Do with Them

Empty Float Tanks and What to Do with Them

There’s a marketing mantra here at Float On that we thought might be useful to share. Especially for people at the more early stages of their float center. The mantra is simple, but it's an integral part of our marketing philosophy, and can go a long way in helping a...

60 vs 90 Minute Float Sessions

60 vs 90 Minute Float Sessions

I've had the pleasure of giving tours of our HelmBot software. While some of these tours are to established centers looking to switch scheduling softwares, most of the tours have been to centers in the final stages of opening. In talking about how to set up "The Helm"...

A Resource for Buying / Selling Used Float Tanks

A Resource for Buying / Selling Used Float Tanks

Save Money When Starting a Float Center Construction aside, one of the more significant costs to starting a float center are the tanks themselves. There are numerous float tank manufacturers to choose from with costs that range quite a bit. A lot of the newer float...

How To Give a Proper Walkthrough

How To Give a Proper Walkthrough

Why Float Centers Need “Walkthroughs” First time floaters typically need some instruction before they can get in the tank. A lot of things can go wrong if a client is not well informed before they attempt to float. In many cases, the first float is the most important...